< Previous | Contents | Next >

72 SEATS AND RESTRAINTS


image

number that positions were saved to. Try storing the position to the other memory button or try the other RKE transmitter.

Easy Exit Recall

Easy Exit Recall is not linked to an

RKE transmitter. The position stored to B is used for all drivers. To turn

Easy Exit Recall on or off, see "Vehicle Personalization Settings" previously in this section and Vehicle Personalization 0 168.

If turned on, the position saved to B

is automatically recalled when one of the following occurs:

. The vehicle is turned off and the driver door is opened within a

short time.

. The vehicle is turned off with the driver door open.

To stop Easy Exit Recall movement, press any of the following memory

controls:

. Power seat

. Memory SET, 1, 2, or B

image

. Power mirror, with the driver or passenger side mirror selected

. Power steering wheel

Obstructions

If something has blocked the driver seat and/or power steering wheel

while recalling a memory position, the recall may stop. Remove the

obstruction and try the recall again.

If the memory position still does not recall, see your dealer for service.

Heated and Ventilated Front Seats

image

{ Warning

If temperature change or pain to the skin cannot be felt, the seat

heater may cause burns. To reduce the risk of burns, use care when

using the seat heater, especially for long periods of time. Do not place

anything on the seat that insulates against heat, such as a blanket,

cushion, cover, or similar item. This

(Continued)


image

image

Warning (Continued)

may cause the seat heater to

overheat. An overheated seat heater may cause a burn or may damage

the seat.


image

If equipped, the buttons are near the climate controls on the center stack. To operate, the ignition must be on.

Press J or z to heat the driver or

passenger seat cushion and seatback.

Press I or + to heat the driver or passenger seatback only.


Press C or { to ventilate the driver or passenger seat.

Press the button once for the highest

setting. With each press of the button, the seat will change to the next lower setting, and then to the off setting.

The indicator lights above the buttons indicate three for the highest setting

and one for the lowest. If the front heated seats are on high, the level may automatically be lowered after approximately 30 minutes.

When this feature is off, the heated and ventilated seat symbols on the buttons are white. A ventilated seat has a fan that pulls or pushes air

through the seat. The air is not

cooled. When a heated seat is turned on, the symbol turns red. When a

ventilated seat is turned on, the symbol turns blue.

The passenger seat may take longer to heat up.

Auto Heated and Ventilated Seats

If the vehicle is equipped with auto heated or ventilated seats, and the

ignition is on, this feature will


image

automatically activate the heated or ventilated seats at the level required by the vehicle's interior temperature.

The active high, medium, low, or off heated or ventilated seat level will be indicated by the manual heated and

ventilated seat buttons on the center stack. Use the manual heated and

ventilated seat buttons on the center

stack to turn auto heated or ventilated seats off. If the passenger seat is

unoccupied, the auto heated or ventilated seats feature will not

activate that seat. The auto heated and ventilated seats feature can be programmed to always be enabled when the vehicle is on. If equipped

with a heated steering wheel, the auto heated steering wheel activation will

follow the heated seat auto activation and the heated wheel indicator will

follow the state of the steering wheel heat.

See Vehicle Personalization 0 168.

Remote Start Heated and Ventilated Seats

If equipped, the heated seats will turn on automatically during a remote

start if it is cold outside and the

image

SEATS AND RESTRAINTS 73


image

ventilated seats will turn on

automatically if it is hot outside.

If equipped, the heated steering wheel will turn on automatically during a

remote start if it is cold outside. The heated and ventilated seat indicators and heated steering wheel indicator may not come on during this

operation.

The heated and ventilated seats and heated steering wheel may cancel

when the vehicle is started. These features can be manually selected after the ignition is turned on.

The temperature performance of an

unoccupied seat may be reduced. This is normal.

The heated or ventilated seats will not turn on during a remote start unless

they are enabled in the vehicle personalization menu.

See Remote Vehicle Start 0 42 and

Vehicle Personalization 0 168.

image