< Previous | Contents | Next >
Headlamp Wiring
An electrical overload may cause the lamps to go on and off, or in some
cases to remain off. Have the
headlamp wiring checked right away if the lamps go on and off or remain off.
Windshield Wipers
If the wiper motor overheats due to heavy snow or ice, the windshield
wipers will stop. Wiper function is
available immediately after the wiper switch is set to off, and back to on.
To protect the wiper motor from overheating, the wipers may slow
down when the windshield is dry for a long period of time. If a period of dry operation, or little moisture, exceeds
10 minutes, the wipers may switch to intermittent operation, and remain
there. When moisture is again
detected on the windshield, wiper
operation will return to the operator selected speed.
Although the circuit is protected from electrical overload, overload due to
heavy snow or ice may cause wiper
linkage damage. Always clear ice and heavy snow from the windshield
before using the windshield wipers.
If the overload is caused by an
electrical problem and not snow or ice, be sure to get it fixed.
Fuses and Circuit Breakers
The wiring circuits in the vehicle are protected from short circuits by a
combination of fuses and circuit breakers. This greatly reduces the
chance of damage caused by electrical problems.
{ Danger
Fuses and circuit breakers are
marked with their ampere rating.
Do not exceed the
specified amperage rating when
replacing fuses and circuit breakers.
Use of an oversized fuse or circuit breaker can result in a vehicle fire.
You and others could be seriously injured or killed.
To check a fuse, look at the
silver-colored band inside the fuse. If the band is broken or melted,
replace the fuse. Be sure to replace a bad fuse with a new one of the
identical size and rating.
Fuses of the same amperage can be temporarily borrowed from another fuse location, if a fuse goes out.
Replace the fuse as soon as possible.
Engine Compartment Fuse Block
The underhood fuse block is on the driver side of the engine
compartment.
Lift the fuse block cover to access the fuses.
The vehicle may not be equipped with all of the fuses and relays shown.
Caution
Spilling liquid on any electrical component on the vehicle may
damage it. Always keep the covers on any electrical component.
1 –
VEHICLE CARE 341
2 Power coolant pump
3 –
342 VEHICLE CARE
4 Traction power inverter 1
5 Transmission/ Ignition
6 –
45 | Washer |
46 | Front sensor |
47 | Left cornering LED |
48 | – |
49 | – |
50 | Engine control module relay |
51 | Wiper speed relay |
45 | Washer |
46 | Front sensor |
47 | Left cornering LED |
48 | – |
49 | – |
50 | Engine control module relay |
51 | Wiper speed relay |
8 | Starter pinion |
9 | Horn |
10 | – |
11 | – |
12 | – |
13 | High-beam |
8 | Starter pinion |
9 | Horn |
10 | – |
11 | – |
12 | – |
13 | High-beam |
29 | Front heated seats |
30 | – |
31 | HDLP/DRL/ Right headlamp |
32 | Air conditioning control module |
33 | – |
34 | – |
35 | Engine control module IGN2 |
29 | Front heated seats |
30 | – |
31 | HDLP/DRL/ Right headlamp |
32 | Air conditioning control module |
33 | – |
34 | – |
35 | Engine control module IGN2 |
7 Starter motor
21 Air conditioning clutch
22 –
23 Coolant heater control module
24 Cabin coolant pump
36 Engine control module IGN1
37 Coolant pump/
Ignition coils–odd
39 | Non walk |
40 | Instrument cluster |
41 | – |
42 | Fuel pump power module |
43 | Instrument panel body/Ignition |
44 | Aeroshutter |
39 | Non walk |
40 | Instrument cluster |
41 | – |
42 | Fuel pump power module |
43 | Instrument panel body/Ignition |
44 | Aeroshutter |
38 Ignition coils–even/ Non walk 2
25 | Cabin coolant pump |
26 | relay Hi fuel |
27 | Steering column lock |
28 | Rear heated seats |
14 | headlamps Air conditioning |
control relay | |
15 | Starter motor relay |
16 | Starter pinion relay |
17 | Run/Crank relay |
18 | Right cornering LED |
19 | – |
20 | High-beam headlamp relay |
25 | Cabin coolant pump |
26 | relay Hi fuel |
27 | Steering column lock |
28 | Rear heated seats |