< Previous | Contents | Next >
Wi-Fi
INSTRUMENTS AND CONTROLS 177
Universal Remote
This allows selection of restoring vehicle settings.
Select Restore or Cancel.
Select and the following may display:
. Wi-Fi
. Manage Wi-Fi Networks
System
See Radio Frequency Statement 0
426.
Clear All Private Data
This allows selection to clear all
private information from the vehicle. Select Delete or Cancel.
Restore Radio Settings
This allows selection to restore radio settings.
Select Restore or Cancel.
Software Information
Touch to view or update the version of the infotainment system software.
Wi-Fi
This feature allows Wi-Fi networks to be turned off or on.
Select Off or On.
Manage Wi-Fi Networks
Select to manage Wi-Fi networks.
Wi-Fi must be on for this feature to be accessed.
Universal Remote System Programming
If equipped, these buttons are in the overhead console.
This system can replace up to three remote control transmitters used to activate devices such as garage door
openers, security systems, and home automation devices. These
178 INSTRUMENTS AND CONTROLS
instructions refer to a garage door opener, but can be used for other devices.
Do not use the Universal Remote
system with any garage door opener that does not have the stop and
reverse feature. This includes any garage door opener model
manufactured before April 1, 1982.
Read these instructions completely before programming the Universal
Remote system. It may help to have another person assist with the
programming process.
Keep the original hand-held
transmitter for use in other vehicles as well as for future programming.
Erase the programming when vehicle ownership is terminated. See “Erasing Universal Remote System Buttons”
later in this section.
To program a garage door opener,
park outside directly in line with and
facing the garage door opener receiver.
Clear all people and objects near the garage door.
Make sure the hand-held transmitter has a new battery for quick and
accurate transmission of the radio-frequency signal.
Programming the Universal Remote System
For questions or programming help, see www.homelink.com/gm or call
1-800-355-3515.
Programming involves time-sensitive
actions, and may time out causing the procedure to be repeated.
To program up to three devices:
1. Hold the end of the hand-held
transmitter about 3 to 8 cm (1 to 3 in) away from the Universal
Remote system buttons with the indicator light in view. The
hand-held transmitter was
supplied by the manufacturer of the garage door opener receiver.
2. At the same time, press and hold both the hand-held transmitter
button and one of the three Universal Remote system
buttons to be used to operate the garage door. Do not release either
button until the indicator light changes from a slow to a rapid
flash. Then release both buttons.
Some garage door openers may require substitution of Step 2
with the procedure under “Radio
Signals for Canada and Some Gate Operators” later in this
section.
3. Press and hold the newly
programmed Universal Remote system button for five seconds while watching the indicator
light and garage door activation.
. If the indicator light stays on continuously or the garage
door moves when the button
is pressed, then programming
is complete. There is no need to complete Steps 4–6.
. If the indicator light does not come on or the garage door
does not move, a second button press may be
required. For a second time, press and hold the newly
programmed button for