< Previous | Contents | Next >

Restore Vehicle Settings






Universal Remote

This allows selection of restoring vehicle settings.

Select Restore or Cancel.

Select and the following may display:

. Wi-Fi

. Manage Wi-Fi Networks


See Radio Frequency Statement 0


Clear All Private Data

This allows selection to clear all

private information from the vehicle. Select Delete or Cancel.

Restore Radio Settings

This allows selection to restore radio settings.

Select Restore or Cancel.

Software Information

Touch to view or update the version of the infotainment system software.


This feature allows Wi-Fi networks to be turned off or on.

Select Off or On.

Manage Wi-Fi Networks

Select to manage Wi-Fi networks.

Wi-Fi must be on for this feature to be accessed.

Universal Remote System Programming


If equipped, these buttons are in the overhead console.

This system can replace up to three remote control transmitters used to activate devices such as garage door

openers, security systems, and home automation devices. These



instructions refer to a garage door opener, but can be used for other devices.

Do not use the Universal Remote

system with any garage door opener that does not have the stop and

reverse feature. This includes any garage door opener model

manufactured before April 1, 1982.

Read these instructions completely before programming the Universal

Remote system. It may help to have another person assist with the

programming process.

Keep the original hand-held

transmitter for use in other vehicles as well as for future programming.

Erase the programming when vehicle ownership is terminated. See Erasing Universal Remote System Buttons

later in this section.

To program a garage door opener,

park outside directly in line with and

facing the garage door opener receiver.

Clear all people and objects near the garage door.



Make sure the hand-held transmitter has a new battery for quick and

accurate transmission of the radio-frequency signal.

Programming the Universal Remote System

For questions or programming help, see www.homelink.com/gm or call


Programming involves time-sensitive

actions, and may time out causing the procedure to be repeated.

To program up to three devices:

1. Hold the end of the hand-held

transmitter about 3 to 8 cm (1 to 3 in) away from the Universal

Remote system buttons with the indicator light in view. The

hand-held transmitter was

supplied by the manufacturer of the garage door opener receiver.

2. At the same time, press and hold both the hand-held transmitter

button and one of the three Universal Remote system

buttons to be used to operate the garage door. Do not release either

button until the indicator light changes from a slow to a rapid

flash. Then release both buttons.

Some garage door openers may require substitution of Step 2

with the procedure under Radio

Signals for Canada and Some Gate Operatorslater in this


3. Press and hold the newly

programmed Universal Remote system button for five seconds while watching the indicator

light and garage door activation.

. If the indicator light stays on continuously or the garage

door moves when the button

is pressed, then programming

is complete. There is no need to complete Steps 46.

. If the indicator light does not come on or the garage door

does not move, a second button press may be

required. For a second time, press and hold the newly

programmed button for