Turn and Lane-Change Signals

light outside when the vehicle leaves the garage, there is a slight delay

before the automatic headlamp

system changes to the DRL. During

that delay, the instrument cluster may not be as bright as usual. Make sure

the instrument panel brightness

Control 0 185.

When it is bright enough outside, the

headlamps will turn off or may change to Daytime Running Lamps (DRL).

The automatic headlamp system turns off when the exterior lamp control is

turned to O or the ignition is off.

For vehicles sold in Canada, this control only works when the

transmission is in P (Park).

Lights On with Wipers

If the windshield wipers are activated in daylight with the engine on, and

the exterior lamp control is in AUTO, the headlamps, parking lamps, and

other exterior lamps come on. The

transition time for the lamps coming on varies based on wiper speed. When the wipers are not operating, these

lamps turn off. Move the exterior

lamp control to O or ; to disable

this feature.

Hazard Warning Flashers

| : Touch this button to make the

front and rear turn signal lamps flash on and off. Touch again to turn the

flashers off.

The hazard warning flashers turn on automatically if the airbags deploy.

Turn and Lane-Change Signals

Move the lever all the way up or down to signal a turn.

An arrow on the instrument cluster

flashes in the direction of the turn or lane change.

Raise or lower the lever until the

arrow starts to flash to signal a lane change. Hold it there until the lane

change is completed. If the lever is

briefly pressed and released, the turn signal flashes three times.

The turn and lane-change signal can

be turned off manually by moving the lever back to its original position.